To access the Advanced Mode, select Advanced Mode or press the hotkey for the advanced BIOS settings. Click the UEFI Firmware settings option.Under the “Advanced startup” section, click the Restart now button.– If these doesn’t work do reset BIOS to default first, while it’s in BIOS press F9 then reboot. – Start by doing a hard reboot, remove the battery and unplug the AC adapter then press and hold the power button for 20 seconds then try booting it up again. Please do try these troubleshooting steps that may help. How do I fix my HP InsydeH20 setup utility? Turn off your computer and restart it with the USB device connected.Leave the boot list option set to UEFI.Disable Secure Boot in the boot option.Boot the computer and press F2 to enter the BIOS.Shut down the machine and start it again with the USB device attached.Disable secure boot in the boot options screen.Start the machine and hit F2 to get to BIOS.Once you are in the BIOS main menu, press the (Tab ↹) and Fn keys at the same time, then press the F10 key.First you enter the BIOS by repeatedly pressing the F2 key immediately after boot.Controller type is changed to AHCI mode (will cause Windows 0x7B Inaccessible Boot Device BSOD unless you start it in safe mode at least once to reconfigure storage controller drivers). Computer is at least 85% charged and not connected to AC power.ĩ. Legacy support mode is enabled (dual UEFI-legacy mode).Ĩ. Fast shutdown is disabled in Windows 10 to force full shutdown.Ĥ. If it does not work for you on the first try, check the following (most important points come first):Ġ. Sometimes, you have to only start pressing the F2 key about 2-3 seconds after you first press the power button to turn the laptop on. You need to press the power button to power the laptop off, then wait a couple of minutes before retrying. If you don't get in, you cannot immediately retry by pressing ESC or CTRL+ALT+DEL. I had to try many times afterwards to get the correct timing for this to work. You may get the advanced mode menu upon reboot. You may have to enter this 2-3 times before it will restart.Ĥ. While in Windows, open an elevated Command Prompt window.ģ. Press the F2 key FIVE times quickly (wait 1 second).ġ. Insert a USB flash drive (may need to be formatted NTFS and/or bootable to work).Ĥ. Turn off the computer fully (not fast shutdown). Disabling these options allow me to flash a modded BIOS using Intel Flash Programming Tool within Windows (without having to use a HW programmer).ġ. It allows you to disable CPU MSR lock, disable BIOS lock, disable Flash Protection Range Registers (allows Intel FPT to flash your BIOS) and enable SPD flash write, among many other options that I have not yet explored. I only tested this to work on a Lenovo Yoga 730-15IWL and a Yoga 730-13IKB.

Insydeh20 bios unlock